Board RSSIt is currently Sat Mar 20, 2010 2:43 am
92 325i, hard line to master cylinder connection
2 posts • Page 1 of 1
92 325i, hard line to master cylinder connection
by Jl420 on Fri Feb 05, 2010 10:19 pm
I did the auto to manual swap and it ran fine for a few months.when I was driving it the hard line came out of the master cylinder. There is no threads, and if I just put it in it slips out when pressure is built back up. Is there a clip? Where does it go? Please help!
-
Jl420 - Rookie
- Posts: 1
- Joined: Fri Feb 05, 2010 9:56 pm
- Cars: 92 - 325i
Re: 92 325i, hard line to master cylinder connection
by 96_323 on Sat Feb 06, 2010 7:43 pm
A jubilee clip
http://www.caskwidge.com/shop/images/jubilee_clip.jpg
is what you need on it, there should really be a shoulder on the male side of the connection. Make sure to check that it has'nt broken off and sitting in the tube somewhere.
http://www.caskwidge.com/shop/images/jubilee_clip.jpg
is what you need on it, there should really be a shoulder on the male side of the connection. Make sure to check that it has'nt broken off and sitting in the tube somewhere.
The ONLY Hellrot Red 323 in the world, emmm except for the other few thousand dotted around the world.
-
96_323 - Guru
- Posts: 272
- Joined: Tue Sep 22, 2009 6:34 pm
- Location: Dublin
- Cars: 96 323i,2.5 twin turbo legnum
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests