[phpBB Debug] PHP Notice: in file /includes/prime_links.php on line 68: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Notice: in file /includes/prime_links.php on line 69: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
BMW E36 Forum • 92 325i, hard line to master cylinder connection | BMW E36 Forum

BMW E36 Forum

The Ultimate BMW E36 Forum . . . Everything you'll need to know about BMW E36 cars will be found here! Join the discussion
https://www.bmwe36blog.com/forum/

92 325i, hard line to master cylinder connection

https://www.bmwe36blog.com/forum/viewtopic.php?f=3&t=501

Page 1 of 1

92 325i, hard line to master cylinder connection

PostPosted: Fri Feb 05, 2010 10:19 pm
by Jl420
I did the auto to manual swap and it ran fine for a few months.when I was driving it the hard line came out of the master cylinder. There is no threads, and if I just put it in it slips out when pressure is built back up. Is there a clip? Where does it go? Please help!

Re: 92 325i, hard line to master cylinder connection

PostPosted: Sat Feb 06, 2010 7:43 pm
by 96_323
A jubilee clip
http://www.caskwidge.com/shop/images/jubilee_clip.jpg
is what you need on it, there should really be a shoulder on the male side of the connection. Make sure to check that it has'nt broken off and sitting in the tube somewhere.
All times are UTC
Page 1 of 1
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/