BMW E36 Forum

i have the sump finally sorted took the anti tole bar out and turned it around welded the brackets on behind the sub frame and used 10 mm spacers to drop the back of the wish bone down to fit the anti role bar back in place lined up perfect and in the middle of welding up my engine mounts
wont be long before shes all 2 gather

Sounds like it's coming together nicely. Might have to get some pictures up for us?

yeah i was lookin on the page and dont no how 2 up load the pics.. andy idea how 2? cause ive loads of them

Quickest way is jump onto bayimg.com, upload your pic then take the address and put it inside img tags:
[img]address[/img]

If you click the post a reply button rather than using the box at the bottom, there's an img button too.

[img]http://bayimg.com/jabBnaAea[/img]

[img]http://bayimg.com/KaBbeAaeA[/img]

thats my car that i started with.. or it should be if the images showed up

and this is the engine bay atm preping it to be sprayed..
[img]http://bayimg.com/kabbIaAEA[/img]

ill have more up 2 morrow just have 2 up load them all

[url]http://image.bayimg.com/jabbnaaea.jpg[/url]
[url]http://image.bayimg.com/kabbeaaea.jpg[/url]
[url]http://image.bayimg.com/kabbiaaea.jpg[/url]
Here's links to the pics.
I was going to embed them for you but they're huge!

Looks good.
How it coming along?

ive me mounts half made the car is going down the end of september to me mate to get it all wired up to start on the key..
ive pictures of them too just have to put them up too..
they took a lot of time to do and i ran out of welding rods so just a matter of getting more and getting stuck in.

http://bayimg.com/kabmbaaep
as ya can see my very skilled way in leveling the engine 2 pieces of wood ha ha but it done the job along wit the 10 straps to level the engine and have it square with the body.
http://bayimg.com/kaBMGAAEp
theres the engine half strapped up..
1 side only took me like 5 hours 2 do and get right..
the other side took just as long havent any pics of it yet but ill have them up once the engines sitting in..
http://bayimg.com/kaBmIAAeP
and theres the mount half made have to add some more supports into it and it will be ready to go
hope the pics show up this time lol
and dont mind the oil all over the block i put that there..

My E36 got also m30b35 after the 1.6 blew skyhigh...
it didn't fit very well, not much room to play with under the bonnet, but doable.
quite a beast with the new engine, need lsd fast, welded diff is horrible. When wet, its like driving on ice, have to be extra cautios with throttle.
Sorry I can't post any pics, its my first post on this forum.

which diff did you ended up using?