Page 1 of 1
performance and mods
Posted:
Sun May 24, 2009 12:51 amby Pat
Has anybody installed the older style intake manifold (OBD1, '92-95) on a newer (OBD2, '96-98) vehicle? I've looked at different installation kits and thought the Bimmerword kit looked the best, until I recieved it. I like the Bimmerworld special silicone hose, but I don't like the fact that it eliminates the support brackets for the oil separator and idle control motor. Does anybody know if the conversion kit from Turner Motorsports use the brackets?
Thanks, Pat
Re: performance and mods
Posted:
Wed Jun 24, 2009 9:33 pmby Pat
Nobody has been able to offer me any advise on converting to the older intake plenum, so I'll do the updating. After looking at the conversion kit and reading the instructions from Turner Motorsports, I ordered it and returned the original kit to Bimmerworld. The TM kit uses the original component pieces from the original intake plenum. It uses all the original brackets to support the components.
More later,
Pat
Re: performance and mods
Posted:
Thu Jul 23, 2009 9:47 amby VMZ
How are you finding the performance? Was it worth losing some of the low end torque for top end power?
Re: performance and mods
Posted:
Tue Oct 27, 2009 11:59 pmby 323isguy
What is the best cheap exhaust for a 99 323is